ACCUMULATOR GP-BRAKE 1119040 - Caterpillar

3. Remove water line (2) from the engine.4. Remove electric wire (1) from the clips that hold it to the engine oil cooler.5. Remove the bolt that holds oil level gauge tube (3) to the engine oil cooler. 6. Loosen clamp (4) that holds the hose to the elbow. 7. Remove the bolt that holds pipe (5) to the cylinder block.8. Remove the bolts that hold oil cooler (6) and oil filter base (8) together.9. Remove the bolts (7) that hold oil cooler (6) to the transmission oil cooler bonnet.10. Remove oil cooler (6) and pipe (5) from the engine as a unit.11. Remove pipe (5) from oil cooler (6). 12. Clean the tubes of the engine oil cooler with a .156 in. (3.97 mm) diameter rod used as shown.Install Engine Oil Cooler
1. Install the gasket and pipe (2) to oil cooler (1) as shown. 2. Make sure the hose is in position on the end of pipe (2). Put clean engine oil on O-ring seals (4) for the engine oil filter base.3. Put oil cooler (1) and pipe (2) in position. Make sure the gasket is installed between oil cooler (1) and the transmission oil cooler bonnet. Install the bolts that hold oil cooler (1) and pipe (2) in position.4. Tighten the clamps for hose (3). 5. Install electric wire (7) in the clips that hold it to the engine oil cooler.6. Install the bolt that holds oil level gauge tube (5) to the engine oil cooler.7. Install water line (6).8. Install the panel assembly on the right side of the rear frame.9. Fill the cooling system with coolant to the correct level.