ACCUMULATOR GP-RIDE CONTROL 2211755 - Caterpillar

Illustration 1 g03851574The following list contains some of the functions of the display module:
The diagnostic codes of the ECM systems are displayed.
The settings for the ECM are displayed.
The machine status parameters are shown in real time.
The number of occurrences and the clock hour of the first and last occurrence are displayed for each of the events, active codes, and logged codes.
The definition for each logged diagnostic code and each event is displayed.Troubleshooting Procedures
The diagnostic codes can be viewed with the Display Module or Cat® Electronic Technician (Cat ET) Service Tool.The following procedures may cause new diagnostic codes to be logged. Therefore, before any procedures are performed, make a list of all the active diagnostic codes to determine the system problems. When each procedure is complete, clear the diagnostic codes that were caused by the procedure.Note: Before performing a procedure, always check all the circuit breakers. Repair the cause of any circuit breaker that has tripped.Event Identifier (EID)
An Event indicates a reading that is outside of normal operating ranges but within component limits. An example might be a high oil temperature reading. The event will be identified by the ECM, the EID, and a time stamp.Component Identifier (CID)
The Component Identifier is a four-digit number that represents a particular component on the machine. For example, each solenoid that is connected to the Machine ECM has an assigned number. Failure Mode Identifier (FMI)
The codes for the Failure Mode Identifier are defined by SAE standards. The following list contains a Caterpillar version of definitions.
Table 1
Failure Mode Identifier
FMI Description of Failure
00 Data valid but above normal operating range
01 Data valid but below normal operating range
02 Data erratic, intermittent, or incorrect
03 Voltage above normal or shorted high
04 Voltage below normal or shorted low
05 Current below normal or open circuit
06 Current above normal or grounded circuit
07 Mechanical system not responding properly
08 Abnormal frequency, pulse, or period
09 Abnormal update
10 Abnormal rate of change
11 Failure mode not identifiable
12 Bad device or component
13 Out of calibration
14 Not used
15 Not used
16 Parameter not available
17 Module not responding
18 Sensor supply fault
19 Condition not met
20 Not used Limp Home Operation
The operator will be alerted of the Steering Limp Home option when a Level 3 Warning appears for one of the following Event codes:
E192
E256
E257
E258The operator will be prompted by the following instructions:
Set Gear to N
Set Park Brake
Low Idle RequiredOnce the operator has entered Limp Home Mode, the Limp Home Mode Icon (2) will be displayed in the left banner.