ACCUMULATOR GP-RIDE CONTROL 3076505 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 138-7574 Link Bracket 2 Start By:a. Release the hydraulic system pressure.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. Prevent fluid loss and helps to keep contaminants from entering the system.
Illustration 1 g06031224
Disconnect hose assemblies (1), (2), (3), and (4).
Illustration 2 g06031232
Disconnect hose assemblies (5), (6), and (7).
Illustration 3 g06031237
Disconnect hose assemblies (8) and (9). Remove bolts (10). Disconnect harness assembly (11).
Illustration 4 g01210264
Attach Tooling (A) and a suitable lifting device to swing motor (12). The weight of swing motor (12) is approximately 77 kg (170 lb). Remove bolts (13). Remove swing motor (12).Installation Procedure
Illustration 5 g01210264
Attach Tooling (A) and a suitable lifting device to swing motor (12). The weight of swing motor (12) is approximately 77 kg (170 lb). Install swing motor (12). Install bolts (13).
Illustration 6 g06031237
Connect harness assembly (11). Install bolts (10). Connect hose assemblies (8) and (9).
Illustration 7 g06031232
Connect hose assemblies (5), (6), and (7). Tighten hose assemblies (5) to a torque of 150 15N m (110 12lb ft). Tighten hose assemblies (6) and (7) to a torque of 76 4 N m (56 3 lb ft).
Illustration 8 g06031224
Connect hose assemblies (1), (2), (3), and (4). Tighten hose assemblies (1) to a torque of 150 15 N m (110 12 lb ft). Tighten hose assemblies (2), (3), and (4) to a torque of 190 20 N m (140 15 lb ft).