ACCUMULATOR GP-RIDE CONTROL 3257154 - Caterpillar

Removal Procedure
If reusing the exhaust elbow, and or the bellows, refer to Special Instruction, REHS5014, "Reuse Guideline for the Lines Group - Flexpipe on Tier 4 Engines".
Illustration 1 g02726444
Note: Mark the orientation of clamp assembly (3) prior to removal.
Loosen clamp assemblies (1), (3), and (4) .
Slide elbow (5) into bellows (2) in order to gain clearance. Remove the bellows assembly.Installation Procedure
If reusing the exhaust elbow, and or the bellows, refer to Special Instruction, REHS5014, "Reuse Guideline for the Lines Group - Flexpipe on Tier 4 Engines".
Illustration 2 g02726460
Illustration 3 g02726462
Alignment wrap (A) is not shown for photographic purposes.Note: Alignment wrap (A) will be included with the new bellows assembly. The Tooling will be pre-installed on the bellows. Bellows (2) should never be flexed during installation.
The Tooling should not be removed until Step 12.
Place Mark (B) onto elbow (5). Mark (B) should be a distance of Dimension (X) from the end of elbow (5). Dimension (X) is 40 mm (1.6 inch).
Insert elbow (5) into bellows (2). Elbow (5) should be inserted as far as possible without using force. The insertion will minimize the overall length of the bellows assembly and will help with installation.
Illustration 4 g02726444
Alignment wrap (A) is not shown for photographic purposes.
Illustration 5 g02726470
Cutaway view of the ball clamp assembly.
Prior to installation, position both ball clamp assemblies (1) and (4) onto the bellows assembly.
Position the bellows assembly between the clean emissions module and the turbocharger adapter. Adjust the length of elbow (5) in the slip joint at clamp assembly (3) in order to position the bellows assembly.
Verify that the cup of the Ball Joint (E) does not touch the radius of the Ball (D). Position ball clamp (4) and hand tighten ball clamp (4). Measure Dimension (Y) and Dimension (Z). Dimension (Y) and Dimension (Z) should be equal to each other. Repeat the measurements every 90° around ball clamp (4). If necessary, adjust ball clamp (4) .
Repeat Step 7 for ball clamp (1) which is located near the clean emissions module.
Verify that Mark (B) is not visible at the slip joint that is positioned near clamp assembly (3) .Note: Do not use power tools in order to torque clamp assemblies (1), (3), and (4) .
Torque ball clamp (1) to a torque of 35 2 N m (26 1 lb ft).
Torque ball clamp (4) to a torque of 35 2 N m (26 1 lb ft).
Remove Tooling (A) from bellows (2) .
Torque clamp assembly (3) to a torque of 55 8 N m (41 6 lb ft).