ACCUMULATOR GP-BRAKE 3330643 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     185-3630     Strap Wrench As     1    
ZZ     6V-9509     Face Seal Plug     1    
6V-9830 Cap As     1    
6V-9507 Face Seal Plug     1    
6V-9828 Cap As     1    Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.Note: SERVICE DATA: TOOLING (ZZ) WILL NOT BE IDENTIFIED IN PHOTOGRAPHS IN THE REMOVAL OR THE INSTALLATION. THIS TOOLING IS SHOWN IN ORDER TO ASSIST THE EXPERIENCED SERVICEMAN.Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Drain any fuel into a suitable container for storage or disposal.
Illustration 1 g01037855
Use Tooling (A) in order to remove fuel filter (1) .
Disconnect harness assembly (3) .
Disconnect hose assemblies (2) .
Remove bolts (4) .
Remove filter base (5) .Installation Procedure
Illustration 2 g01037855
Install filter base (5) .
Install bolts (4) .
Connect hose assemblies (2) .
Connect harness assembly (3) .
Install fuel filter (1) .