ACCUMULATOR GP-BRAKE 3505576 - Caterpillar

Probable Causes
Electronic Control Module (ECM)
Power to the ECMData Link
Problem in the circuit for the Cat Data Link or the CAN data linkElectrical connectors
Installation of electrical connectorsRecommended Actions
Table 1
Troubleshooting Test Steps Values Results
1. Power to the ECM
A. Check for power to the ECM. Refer to Troubleshooting, "Electrical Power Supply - Test".
B. Connect Cat ET to the service tool connector.
Power to ECM
Result: Cat ET does not connect.
Refer to Troubleshooting, "Electronic Service Tool Does Not Communicate".
2. Problem in the Circuit for the Cat Data Link or the CAN Data Link
A. Verify that the data link does not have an open or short circuit.
Cat Data Link
Result: Refer to Troubleshooting, "Cat Data Link - Test" and Troubleshooting, "CAN Data Link - Test".
3. Installation of Electrical Connectors
Check for correct installation of the J1/P1 and J2/P2 ECM connectors. Check for correct installation of all other applicable connectors.
Electrical Connectors
Result: Refer to Troubleshooting, "Electrical Connectors - Inspect".
Contact your Cat dealer Technical Communicator (TC). For further assistance, your TC can confer with the Dealer Solutions Network (DSN).