ACCUMULATOR GP-RIDE CONTROL 3737018 - Caterpillar

Illustration 1 g01257350For information on inspecting the flywheel housing, refer to Systems Operation/Testing and Adjusting.Note: Before installation of the flywheel housing, inspect the front face of the flywheel housing and the rear face of the cylinder block. The components must be free of the following substances: oil, fuel, water, gasket adhesive, assembly compounds and any other foreign material.To seal the joint between the flywheel housing and the cylinder block, apply a 6 mm (0.250 inch) of 4C-5300 Gasket Sealant or 185-3984 Gasket Sealant to the mating surface of the flywheel housing.During assembly, use the hard washers that are listed in Table 2. (1) Bolt Tighten all the bolts that are shown in View D-D to the following torque: Torque ... 105 20 N m (77 15 lb ft) (2) Seal Lubricate the bore lightly with clean engine oil. (3) Stud Put 4C-9502 Sealant on the nut end of the studs. Torque ... 110 20 N m (80 15 lb ft) (4) Install the two dowels to the following height. ... 3.5 0.5 mm (.14 .02 inch) (5) Install one dowel even with the top face of the housing. (6) Install three dowels to the following height. ... 6.0 0.5 mm (.24 .02 inch)Tighten the bolts that hold the flywheel housing to the engine block evenly. Refer to Table 1 for the correct position.Torque 1/2 - 13 NC ... 135 20 N m (100 15 lb ft)5/8 - 11 NC ... 270 40 N m (200 30 lb ft)
Table 1
Flywheel Housing Bolt Installation Chart Bolt Length
Diameter
inch Bolt Location Part Number mm inch
1/2 A 9X-8873 57.2 2.25
1/2 B 1A-1460 50.8 2.00
1/2 C 1D-4574 152.4 6.00
1/2 D OS-1595 31.8 1.25
5/8 E 5D-9514 158.8 6.25
5/8 F 1D-4597 165.1 6.50
5/8 G 5P-4626 266.7 10.50
Table 2
Diameter
inch Hard Washer
1/2 5P-8245
5/8 5P-8247