ACCUMULATOR GP-BRAKE 3752805 - Caterpillar

Image1
Image2
SERVICE CLAIM ALLOWANCES
Product smu/age whichever comes first Caterpillar Dealer Suggested Customer Suggested
Parts % Labor Hrs% Parts % Labor Hrs% Parts % Labor Hrs%
0-20000 hrs,
0-60 mo 100.0% 100.0% 0.0% 0.0% 0.0% 0.0%
This is a 2.0-hour job
Reimbursement for tank repair by the tank manufacturer is covered at cost. Retain a copy of the invoice for outside expenses in the product history folder for audit purposes. This repair should be scheduled and approved through Caterpillar prior to repair as detailed in the Action Required Section. Attach a copy of the invoice in the SIMSi entry.
PARTS DISPOSITION
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
Rework Procedure
The CEM support braces should be attached to the canopy wall first, and then to CEM mounting bracket. Existing bolt holes in the canopy are to be used. Note that the CEM mounting bracket is not centered, therefore the support braces are different lengths. Attach CEM support braces to each side of the canopy walls using qty 4 of 4L-9337 Bolts, and qty 4 of 5P-1075 washers per side. Refer to Image1.1.1.
Image1.1.1
Use bolt pattern in CEM support braces to mark the location of bolt holes for the CEM mounting bracket. Note that a quantity of 495-2742 Spacers may be needed to allow proper fit-up. Drill holes per pattern to accommodate M10 bolts. Refer to Image1.2.1
Attach CEM support braces to each side of CEM mounting bracket using qty 2 of 8T-4185 Bolts, qty 4 of 7X-7729 Washers, and qty 2 of 344-5675 Nuts per side. Refer to Image1.2.2
Image1.2.1
Image1.2.2
If cracking is found on the top surface of the fuel tank, weld repair by the tank manufacturer will be required. Also, pressure testing of the tank and re-painting of the welded area will be required after.
See Image1.3.1 for example of a typical crack.
Run package and check for proper operation.
Image1.3.1