ACCUMULATOR GP-BRAKE 3826145 - Caterpillar

1. Remove four bolts (1), and remove step (2). Remove three bolts and clamps (3). Remove bolts (5). Remove bracket (4) and lay it away from the hydraulic control valves.2. Remove electrical connection (6). Remove bolt and clamp (7). Remove bolts (8), and remove cover (9) and gasket. 3. Remove ten bolts (10), and remove plate (11). 4. Remove bolts (12), and remove shield (13) from the shift manifold. 5. Remove three plugs (14), and slide out the three tubes from behind the plugs. Remove bolts (15), and remove the cover. 6. Disconnect wire harness (16). Remove bolts (17), and remove switch assembly (18). 7. Remove bolts (19), and remove bolt (20). Remove selector body (21). 8. Remove bolt (21), and remove plate (22). Remove three bolts (23). 9. Remove eight bolts (24), and remove two flanges (25). Remove three nuts (26) and clip. Remove bolt (28), and remove elbow (27). 10. Slide two sleeves (29) out of the manifold and the transmission case. Remove two O-ring seals from each of the sleeves.11. Remove bolts (30), and remove sleeve and elbow (31). Remove the two O-ring seals from the sleeve. Remove two bolts (33). With one hand holding sleeves (32), remove manifold assembly (34).12. Remove the manifold and seven sleeves (32) from manifold assembly (34). Remove the six O-ring seals from the bottom of the manifold. Remove two O-ring seals from each of the seven sleeves.Install Transmission Hydraulic Control Valves
1. Make sure the six O-ring seals are on the bottom side of the manifold. Install the two O-ring seals on each of the seven sleeves (32). Position and install sleeves (32) between the manifold and manifold assembly (34).2. Install sleeves (32) with manifold assembly (34) as a unit. Install bolts (33). Tighten the bolts to a torque