ACTUATOR 1250547 - Caterpillar

Illustration 1 g01197340
Schematic for the Tilt Lever Position SensorThis diagnostic code is recorded when the implement electronic control module (ECM) determines that the signal for the tilt lever position sensor is too low. The lift lever position sensor is a pulse width modulated sensor.The possible causes for this diagnostic code are listed:
The tilt lever sensor needs recalibrated.System Response:The machine response is listed:
If the diagnostic code is active for at least three seconds, then the 353-13 diagnostic code will become active. The 353-01 diagnostic code will become inactive.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear the diagnostic codes when the original diagnostic code is corrected. Note: Ensure that the diagnostic code is active.Test Step 1. RECALIBRATE THE LEVER POSITION SENSOR.Recalibrate the lever position sensor. Refer to Testing and Adjusting, "Position Sensor for the Electrohydraulic Control Levers or Joystick Control (Electronic Technician) - Calibrate".Expected Result:A successful calibration causes this diagnostic code to become inactive. Results:
YES - The calibration causes this diagnostic code to become inactive. Resume normal machine operation. Stop.
NO - The calibration has not caused the diagnostic code to become inactive.Repair: Replace the lever/joystick. Stop.