ACTUATOR AS-VALVE 2764373 - Caterpillar

There may be several specific warning signs on an engine. The exact location of the hazards and the description of the hazards are reviewed in this section. Please become familiar with all warning signs.Ensure that all of the warning signs are legible. Clean the warning signs or replace the warning signs if the words cannot be read or if the pictures are not visible. When the warning signs are cleaned, use a cloth, water, and soap. Do not use solvent, gasoline, or other harsh chemicals to clean the warning signs. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the warning signs. The warning signs that are loosened could drop off of the engine.Replace any damaged warning signs or missing warning signs. If a warning sign is attached to a part of the engine that is replaced, install a new warning sign on the replacement part. Any Caterpillar dealer can provide new warning signs.Do not work on the engine and do not operate the engine unless the instructions and warnings in the Operation and Maintenance Manual are understood. Proper care is your responsibility. Failure to follow the instructions or failure to heed the warnings could result in injury or in death.The warning labels that may be found on the engine are illustrated and described.Read the Operation and Maintenance Manual
Illustration 1 g00750994
The label for reading the Operation and Maintenance Manual is located on the top of the inlet and exhaust manifold.
g00751540Before operating the engine, read the Operation and Maintenance Manual and understand the Operation and Maintenance Manual.Starting Aid
Illustration 2 g00751369
The warning label for the starting aid is located on the air cleaner or near the air cleaner.
g00283559If the engine is equipped with an air inlet heater for cold weather starting, do not use starting aids that contain an aerosol such as ether. Using such types of starting aids could result in an explosion and personal injury.Draining the Coolant
Illustration 3 g00750994
The label for draining the coolant is located on the top of the inlet and exhaust manifold.
g00750975Do not drain the engine coolant prior to reading and understanding the Operation and Maintenance Manual.Electrical System
Illustration 4 g00750997
The warning for the electrical system is located on top of the cover for the alternator.
g00780255This electrical system contains some 12 volt components. Refer to the electrical schematic in the Service Manual, 3054 and 3056 Marine Engine Installation Guide.