ACTUATOR GP-CLAMSHELL 6C6500 - Caterpillar

Brace for the Loader Lift Arms (11)This warning message is located on the right-hand side on the brace for the loader lift arms.
Illustration 13 g01427443
Loader lift arm brace must be in place when working under raised lift arms.Failure to follow the instructions or heed the warnings could result in injury or death.
Refer to Operation and Maintenance Manual, "Loader Lift Arm Brace Operation" for operating information.Accumulator (12)This warning message is located near the accumulator underneath the cab. If your machine is equipped with ride control, there will be an additional accumulator in this location.
Illustration 14 g01372252
Accumulator may contain high pressure oil. Do not service the accumulator or any hydraulic lines until all of the pressure has been relieved. See the Service Manual for proper procedures. Failure to heed this warning could result in injury or death.
Aerosol Starting Aid (13)This warning message is located on the side of the air cleaner housing.
Illustration 15 g01372254
Do not use ether. This machine is equipped with glow plugs. Using ether can create explosions or fires that can cause personal injury or death. Read and follow the engine starting procedure in the Operation and Maintenance Manual.
Armrests (14)This warning message is located inside the cab on the right side by the gauges.
Illustration 16 g01427454
Crush/Ejection Hazard! Could cause serious injury or death.Always wear seatbelt and lower both armrests while operating machine. Read the Operation and Maintenance Manual.
Product Link (15)This warning message is located inside the cab on the right-hand window.
Illustration 17 g01370917
This machine is equipped with a Caterpillar Product Link communication device. When electric detonators are used, this communication device should be deactivated within 12 m (40 ft) of a blast site for satellite-based systems and within 3 m (10 ft) of a blast site for cellular based systems, or within the distance mandated under applicable legal requirements. Failure to do so could cause interference with blasting operations and result in serious injury or death.In cases where the type of Product Link module cannot be identified, Caterpillar recommends that the device be disabled no less than 12 m (40 ft) from the blast perimeter.
High Pressure Grease (16)This warning message is located on both sides of the machine near the access panel for the track tension cylinder. This warning message is only located on CTL machines.
Illustration 18 g01371642
Personal injury can result from grease under high pressure.The adjuster cylinder for the track is under high hydraulic pressure. Grease under high pressure can cause injury.Do not visually inspect the adjuster cylinder to see if grease is released when the valve is opened. Look to see that the track has loosened.
Refer to Operation and Maintenance Manual, "Track - Inspect/Adjust (Detension the Track)" for more information.