ACTUATOR ASSEM. 9P7129 - Caterpillar

Removal Procedure
Table 1
Required Tooling
Tool Part Number Part Description Qty
A - Loctite 596 RTV Silicone High Temp -
B - Loctite 290 Threadlocker - High Strength Wicking Grade -
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Drain the engine oil. Refer to Operation and Maintenance Manual, "Engine Oil and Filter - Change" for the proper draining and filling procedures.
Illustration 1 g06197124
Remove bolts (1), bolts (3), and tube assembly (2).
Illustration 2 g06197129
Use a suitable lifting device to remove oil pan assembly (5). The weight of oil pan assembly (5) is approximately 98 kg (216 lb).
Remove bolts (4), oil pan assembly (5), and the gasket.Installation Procedure
Install oil pan assembly (5) in the reverse order of removal.
Apply Tooling (A) above and below the gasket as required prior to assembly.
Apply Tooling (B) to the threads of bolts (4) as required.