ADAPTER 1163263 - Caterpillar

The new software has varying improvements and features which are listed below:491-2383 Power Train Software Gp (Powershift)
Improved the Engine Starter Relay short to Ground Fault activation feature.
Improved the M-Series Axle Speed Sensor Faults activation feature.
Improved the Auto Differential lock engaging feature to engage at correct times.
Improved to set the time/date and time zone information in Cat ET.
Added support to force ECO mode to "OFF" during park brake drive-through.
Added support for diagnostic code 444-6 Starter Motor Relay: Current Above Normal.
Added support for diagnostic code 605-2 Front Axle Speed Sensor Faults.
Added Support for diagnostic code 608-2 Rear Axle Speed Sensor Faults.
Added E1320 Real-Time Clock Incorrect event.
Added a Datalog that triggers when a Slip Detect Event is Activated.
Improved logic for Transmission Slip Detected Events (E2201, E2202, E2203, E2204, E2205, E2301, E2302, E2303, E2304).The following improvements will be available after a Clutch Fill Calibration:
Improved reverse to forward shift.
Improved 2-3 upshift and 2-1 pile shift.
Improved reverse to forward shift on 980 HD.
Improved 3-2 shift on 966M.489-3190 Power Train Software Gp (XE)
Support provided for password protected machine speed limit setting from display screen.
Support provided for independent machine forward and reverse speed limits setting from display and Cat ET screen.
Improved the strategy and logic for machine fuel economy. Also added support to Display for ON/OFF Economy mode from Display screen.
Added support to enable/pause the auto lube greasing system when machine is in the Not Idle/Other states.
Improved logic for right pedal lock.
Updated CAN Port B to support 250 kbps instead 500 kbps.
Updated core software to support next generation (v2) A5:Mx ECM hardware.514-1252 Implement Software Gp
Improved the 980M Blockhandler Configuration third Function Enablement feature. Hence third function will not be enabled by default for 980 blockhandler machines.
If Park Brake signal and/or lift cylinder extension signal is not valid, then service mode will not be allowed.
When Hose Burst Protection is installed, ride control forward activation speed and ride control reverse activation speed will be overwritten to 6 km/h (3.7 mph) if set to lesser than 6 km/h (3.7 mph).
Improved to enable Indication Light for marker lights, when roading lights are not installed.
Added support to communicate payload data to Visionlink from third-party payload systems.
Changed fuel sender mapping to support new passive fuel sensor.
Added linkage configuration (pop-up), so that Implement accepts only approved linkage values for linkage configuration.
Added support for Distributed Real-Time Clock.
Improved the Autodig Automatic Trigger feature to work under different conditions.
Updated seatbelt monitoring logic, including audible alert if machine is in operation with seat belt unfastened.
Added 1434 Operator Seatbelt Unfastened event.
Removed 1387 Operator Seatbelt Unfastened when the machine is idle event.
Added Ride Control Protection feature which turns off-ride control when digging / ground engagement is detected.
Improved Rack Snubbing on the 980M and 982M.Added support for Hose Burst Protection Strategy integrated with Ride Control. When Hose Burst Protection is installed, ride control service will only be allowed when the ride control button on the keypad is pressed and held for 5 seconds (same as today) and the following conditions are met:
Park brake is engaged.
Lift cylinder extension is lesser than