ADAPTER 1277105 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     138-7574     Link Bracket     2    Start By:
Separate the track assembly. Refer to Disassembly and Assembly, "Track - Seperate" in this manual.
At operating temperature, the hydraulic oil is hot and under pressure. Hot oils can cause burns.To prevent possible personal injury, release the pressure in the implement hydraulic circuit (boom, stick, bucket, and swing), travel circuits, and the hydraulic oil tank at the filler cap before any hydraulic lines or components are disconnected or removed.Remove the filler cap only when the engine is stopped and the filler cap is cool enough to touch.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Release the hydraulic system pressure. Refer to Disassembly and Assembly, "System Pressure - Release" in this manual.
Illustration 1 g00486980
Typical example
Remove four bolts (1) and the washers that hold cover assembly (2). Remove cover assembly (2) from the inside rear of the undercarriage frame.Note: Oil will flow from the tube assemblies when the tube assemblies are disconnected. Oil will flow from the hose assemblies when the hose assemblies are disconnected. Position a pan under the tube assemblies and the hose assemblies in order to collect the drain oil.
Illustration 2 g00486981
Typical example
Disconnect two tube assemblies (3) from the travel drive.
Disconnect hose assemblies (4) and (5) from the travel motor. Put plugs in the ends of the tube assemblies and in the ends of the hose assemblies. Plugs prevent oil loss and contamination of the hydraulic system.
Remove elbow (6) from the travel motor.
Illustration 3 g00486987
Fasten Tooling (A) and a hoist to final drive (7), as shown. Put a slight lifting tension on the final drive.
Illustration 4 g00486988
Remove two plugs (9) from the forcing bolt holes in the undercarriage frame.
Remove 20 bolts (8) and the washers that hold the final drive to the undercarriage frame.
Illustration 5 g00486990
Install two suitable sized forcing bolts (10) in the forcing bolt holes in the frame. Tighten the forcing bolts evenly in order to loosen the final drive from the undercarriage frame.
Carefully remove final drive (7) from the undercarriage frame. The combined weight of the final drive and the travel motor is approximately 400 kg (880 lb).
Remove two forcing bolts (10) from the undercarriage frame.