ADAPTER GP- 1278064 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     6V-9508     Face Seal Plug     1    
6V-9829 Cap As     1    Note: SERVICE DATA: TOOLING (A) AND TOOLING (B) WILL NOT BE IDENTIFIED IN PHOTOGRAPHS IN THE REMOVAL OR THE INSTALLATION. THIS TOOLING IS SHOWN IN ORDER TO ASSIST THE EXPERIENCED SERVICEMAN.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g00871572
Remove bolts (1) and plate (2) .
Illustration 2 g00871573
Illustration 3 g00871576
Remove bolts (5) from bracket (3) .
Remove clamp (4) .
Illustration 4 g00871577
Loosen clamps (6) .
Remove tubes (7) and elbow (8) .
Illustration 5 g00871578
Loosen bolts (9) .
Illustration 6 g00871579
Disconnect hose assembly (10) from turbocharger (11) .
Illustration 7 g00871668
The above photograph was taken beneath the machine.
Remove bolts (12) that fasten the tube assembly to the cylinder block.
Illustration 8 g00871581
Remove nuts (13) .
Remove turbocharger (11) .
Remove gasket (14) .