ADAPTER AS 1488307 - Caterpillar

Event Codes
Table 3
Event Identification List    
EID     Event Description    
5     Fuel Filter Restriction Derate    
15     High Engine Coolant Temperature Derate    
16     High Engine Coolant Temperature Shutdown    
17     High Engine Coolant Temperature Warning    
23     High Hydraulic Oil Temperature Derate    
25     High Inlet Air Temperature Derate    
27     High Inlet Air Temperature Warning    
39     Low Engine Oil Pressure Derate    
43     Low System Voltage Warning    
50     High System Voltage Warning    
53     Low Fuel Pressure Warning    
59     Low Engine Coolant Level Warning    
95     Fuel Filter Restriction Warning    
96     High Fuel Pressure    
100     Low Engine Oil Pressure Warning    
119     Low Fuel Level    
171     Low Engine Oil Level    
172     High Air Filter Restriction    
179     Alternator Not Charging    
180     Autolube Distribution Line Plugged    
181     Limited Mobility Mode    
182     Suction Valve Off    
190     Engine Overspeed Warning    
232     High Fuel/Water Separator Water Level    
234     Low Autolube Grease Level    
235     Low Hydraulic Oil Level    
236     Return Hydraulic Oil Filter Plugged    
237     Machine Overloaded    
265     User Defined Shutdown    
272     Inlet Air Restriction Warning    
273     Unauthorized Key    
600     High Hydraulic Oil Temperature Warning    
862     Attachment Hydraulic Oil Filter Plugged    
863     Abnormal Machine Autolube System Operation    Calibration Error ID List
Table 4
Calibration Error ID List    
ID    Calibration Error Description    
$0001     ECM Fault    
$0002     Active Diagnostic Present    
$0003     Another Calibration is Active    
$0004     Calibration Active by Another ECM    
$0005     Loss of Calibration Interlock    
$0006     Calibration Aborted by Tool/Monitor    
$0007     Requested Display Not Supported    
$0008     Unavailable Display    
$0009     Calibration Aborted by ECM    
$000A     Calibration Failure    
$000B     Calibration Not Supported    
$0100     Out-of-Range Low - Increment/Decrement Parameter    
$0101     Out-of-Range High - Increment/Decrement Parameter    
$0102     Invalid Action/Key Stroke Command    
$0103     Calibration Value Out-of-Range    
$0104     Calibrated Range Too Small    
$0105     Calibrated Range Too Large    
$0106     Calibration Value Not Saved    
$1000     See Service Manual    
$1010     Engine Stopped (No Engine RPM)    
$1011     Engine Running (Engine RPM Present)    
$1012     Engine RPM Incorrect    
$1013     Engine High Idle RPM Too Fast    
$1014     Engine Low Idle RPM Too Slow    
$1015     Abnormal Engine RPM Signal    
$1016     Speed Sensor Circuit is Open    
$1017     Service Brake Pedal Pressed    
$1018     Parking Brake Not Engaged    
$1019     Parking Brake Engaged    
$101A     Implement is Swinging/Traveling    
$101B     Machine Speed Not Zero