ADAPTER-TIP 1959154 - Caterpillar

Table 2
Linkage Bearings    
Item     Bearing Diameter     Depth at Assembly     Part Number for the Bearing    
2    
76.370 0.064 mm (3.0067 0.0025 inch)     Two places
10.5 1.0 mm (0.41 0.04 inch)     1V-9148 Sleeve Bearing    
4    
76.370 0.064 mm (3.0067 0.0025 inch)    
11.5 0.5 mm (0.45 0.02 inch)     1V-9148 Sleeve Bearing    
6    
70.102 0.020 mm (2.7599 0.0008 inch)    
9.25 0.50 mm (0.364 0.020 inch)     3G-5285 Sleeve Bearing    
8    
63.654 0.057 mm (2.5061 0.0022 inch)    
8.50 0.50 mm (0.335 0.020 inch)     4V-8629 Sleeve Bearing    
10    
101.77 0.06 mm (4.007 0.002 inch)    
12.0 2.0 mm (0.47 0.08 inch)     4V-2879 Sleeve Bearing    
12    
70.01 0.05 mm (2.756 0.002 inch)    
8.3 mm (0.33 inch)     4V-2883 Sleeve Bearing    
14    
63.654 0.064 mm (2.5061 0.0025 inch)    
8.4 mm (0.33 inch)     118-1008 Bearing    
16    
70.01 0.05 mm (2.756 0.002 inch)    
8.30 mm (0.326 inch)     4V-2883 Sleeve Bearing    
18    
63.654 0.064 mm (2.5061 0.0025 inch)    
10.0 1.0 mm (0.39 0.04 inch)     7P-3454 Sleeve Bearing    
Illustration 2 g01416071
View A-A (19) As required, use the 176-0624 Washer in order to reduce the gap to less than 1.6 mm (0.06 inch) between the lift arms and the frame assembly. Center the lift arms into the frame assembly by installing the same number and the same thickness of washers between the arm assembly and the inside tower of the frame assembly. (20) As required, use the 176-0623 Washer in order to reduce the gap to less than 1.6 mm (0.06 inch) between the lift arms and the frame assembly. Center the lift arms into the frame assembly by installing the same number and the same thickness of washers between the arm assembly and the inside tower of the frame assembly.
Illustration 3 g01416072
View B-B (21) As required, use the 176-0625 Washer in order to reduce the gap to less than 2.0 mm (0.08 inch) between the lift arms and the bucket. Center the lift arms into the bucket by installing the same number and thickness of washers between the arm assembly and the inside of the bucket. (22) As required, use the 176-0626 Washer in order to reduce the gap to less than 2.0 mm (0.08 inch) between the lift arms and the bucket. Center the lift arms into the bucket by installing the same number and thickness of washers between the arm assembly and the inside of the bucket.