ADAPTER AS 1W3014 - Caterpillar

1. Remove wire (3) from air cleaner switch.2. Remove six nuts and bolts (2) and remove air cleaner (1).3. Remove the bolt and clamp (4).4. Install two 5/8"-11 NC forged eyebolts as shown. Fasten a hoist to the pump drive housing. 5. Remove twelve bolts (5) and remove the pump drive The weight of the pump drive is 350 lb. (158 kg).Install Pump Drive
1. Install two 5/8"-11 NC forged eyebolts in the pump drive housing. Fasten a hoist to the pump drive and put it in position on the flywheel housing. Install the twelve bolts that hold the pump drive in position. 2. Install the clamp and bolt (4). Put air cleaner (1) in position and install six bolts and nuts (2) that hold it in position.3. Install wire (3) on the air cleaner switch.end by:a) install axial piston pump (front and rear)b) install pilot system pumpDisassemble Pump Drive
start by:a) remove pump drive 1. Drain the oil from the pump drive. Remove six bolts (1) that hold bearing cage (2) to the cover. Remove the bearing cage and shims. 2. Remove O-ring seal (4) from the cage. Remove bearing cup (3) with a hammer and punch from the cage. 3. Remove the bolts that hold bearing cages (5) and (6) to the cover. 4. Install two 5/8"-11 NC forcing screws (7) in each cage and remove bearing cages (5) and (6) from the cover. Keep the shims and cages together for installation purposes. 5. Remove bearing cups (8) from the outer cages with tooling (A).6. Remove lip type seal (9) and O-ring seal (10) from the outer cages. 7. Remove the bolts that hold the cover to the case. Install two 1/2"-13 NC forcing screws and loosen the cover from the case. Remove the forcing screws and install two