ADAPTER 2140729 - Caterpillar

No Clearance (11)This warning is on the side face of the loader frame near the articulation hitch on both sides of the machine.
Illustration 12 g01371644
Stay back a safe distance. No clearance for a person in this area when the machine turns. Severe injury or death from crushing could occur.
Leaking Oil (12)This warning label is on both sides of the frame inside the main valve compartment.
Illustration 13 g03541584
Leaking oil onto parking brake while servicing could cause damage to the parking brake, resulting in potential for serious injury or death.
Crush Hazard (13) (If Required)Where regional requirements dictate, this film is installed on both sides of the loader linkage.
Illustration 14 g03888562
Crushing Hazard! Stay back a safe distance. There is no clearance for a person in this area when the lift arms lower or raise. Failure to follow these instructions could cause serious injury or death.
ROPS/FOPS Structure (14)This warning label is located inside the cab of the machine on the front left post.
Illustration 15 g06044308
Structural damage, an overturn, modification, alteration, or improper repair can impair this structure's protection capability thereby voiding this certification. Do not weld on or drill holes in the structure. This will void the certification. Consult your Cat dealer to determine this structure's limitations without voiding its certification.
Certification for Rollover Protective Structure (ROPS) and for Falling Object Protective Structure (FOPS)The unaltered ROPS or the FOPS structure meets the following standards for the ROPS at the time of installation: SAE J1040 MAY94, ISO 3471:1994, SAE J397 OCT95 and ISO 3164:1995. Also, the FOPS canopy meets the following standards at the time of installation: SAE/ISO3449 APR98 LEVEL II and ISO 3449:1992 LEVEL II.Seat Belt (15)This warning is located inside the cab on the right-hand cab post.
Illustration 16 g01371636
A seat belt should be worn at all times during machine operation to prevent serious injury or death in the event of an accident or machine overturn. Failure to wear a seat belt during machine operation may result in serious injury or death.
High Pressure Cylinder (16)This warning is on the accumulator in the following three locations: the service center on the right side of the machine, in the right side of the non-engine end frame and near the main hydraulic control valve.
Illustration 17 g01370912
Pressurized System!Hydraulic accumulators contain gas and oil under high pressure. DO NOT disconnect lines or disassemble any component of a pressurized accumulator. All gas pre-charge must be removed from the accumulator as instructed by the service manual before servicing or disposing of the accumulator or any accumulator component.Failure to follow the instructions and warnings could result in personal injury or death.Only use dry nitrogen gas to recharge accumulators. See your Cat dealer for special equipment and detailed information for accumulator service and charging.