ADAPTER-TIP 2322171 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     256-4866     Seal Protector
C0.5, C0.7, 3011C/C1.1 and C1.6 engines     1    
256-4871 Seal Protector
3013C/C1.5, 3024C/C2.2 and 3024CT/C2.2 engines     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
If the front housing is not installed, do not turn the crankshaft. Damage to the engine may occur.
Clean all surfaces thoroughly.
Install the appropriate tool (A) on the crankshaft.
Illustration 1 g01129575
Typical example
Align the locating pin (2) with the locating hole on the oil pump cover (1) . Ensure that the oil pump cover is concentric to the idler gear assembly.
Install a new joint to the front of the cylinder block (6) .
Turn the mechanical stop lever (3) to the full clockwise position so that the spring is held under tension. Observe the position of the linkage for the fuel injection pump (not shown) in the front housing.
Position the front housing (4) on the front of cylinder block (6) . Guide the linkage for the fuel injection pump into position so that the link is free to move inside the aperture on the cylinder block for the fuel injection pump.
Align the front housing (4) with the dowels in the front of the cylinder block (6) . Press the front housing into position. Release the stop lever (3) .
Install the fasteners (5) finger tight.
Tighten the fasteners (5) to a torque of 10 N m (7 lb ft).
Remove tool (A) from the crankshaft.If the front housing has been replaced or the governor linkage has been replaced, check the maximum engine speed at no load. Refer to Testing and Adjusting, "Engine Speed Check".End By:
Install the crankshaft pulley. Refer to Disassembly and Assembly, "Crankshaft Pulley - Remove and Install".
Install the fuel injection pump. Refer to Disassembly and Assembly, "Fuel Injection Pump - Install".