ADAPTER-TIP 2322174 - Caterpillar

Illustration 1 g01375188
Connections of the starter relayThis diagnostic code is associated with the starter relay. The FMI 05 means that the ECM has determined that the current of the relay is below normal.The possible causes of this diagnostic code are listed below:
The energize circuit of the relay is open.
The return circuit of the relay is open.
The relay has failed.
The ECM has failed. This is unlikely.Before performing this procedure, inspect the harness connectors that are involved in the circuit. Poor connections can often be the cause of a problem in an electrical circuit. Verify that all of the connections in the circuit are clean and secure. If a problem with a connection is found, correct the problem and verify that this diagnostic code is active before performing this procedure.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 0444 FMI 05 is active before performing this procedure.Note: Use a digital multimeter for the measurements in this procedure.Note: The coil resistance of the start relay should measure 81 ohms to 113 ohms at 25 °C (77 °F). Test Step 1. CHECK THE RELAY.
Turn the disconnect switch and the key start switch to the ON position. Do not start the engine.
Disconnect the start relay from the machine harness.
At the machine harness connector for the relay, place a jumper wire from contact 5 (wire 306-GN) to contact 2 (wire J765-BU).
Observe the status of the diagnostic code.Expected Result:The diagnostic code remains active. The FMI has not changed and the "FMI 05" is still active.Results:
YES - The diagnostic code remains active. The jumper wire does not affect the diagnostic code. Proceed to Test Step 2.
NO - The diagnostic is no longer active. The relay has failed.Repair: The relay has failed. Repeat this test in order to verify the failure of the relay. Replace the relay. Verify that the new relay corrects the problem.STOPTest Step 2. CHECK THE HARNESS FOR AN OPEN.
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness connector J2 from the ECM.
The jumper wire that was installed in the previous test step remains in place.
At the machine harness connector, measure the resistance from signal contact J2-7 (wire 306-GN) to contact J2-8 (wire J765-BU).Expected Result:The resistance is less than 5.0 ohms.Results:
OK - The resistance is less than 5.0 ohms. The machine harness is correct. Proceed to Test Step 3.
NOT OK - The resistance is greater than 5000 ohms. The resistance measurement is not correct. There could be an open or a faulty connector in the machine harness.Repair: A resistance measurement that is more than 5.0 ohms but less than 5000 ohms may indicate a problem with one of the harness connectors in the circuit. A connector may be loose or corroded. Inspect the connectors that are in the circuit. Ensure that all of the connections are clean and secure.A measurement that is