ADAPTER-FAN 2502249 - Caterpillar

(21)Transmission, Bevel Gear And Steering Clutch Compartment
1. Oil should be warm before draining. Remove bevel gear drain plug. 2. Remove converter drain plug.3. Change filter elements. Wash magnetic strainers. See Item (7).4. Install all drain plugs. 5. Remove 2 breathers and install new ones.6. Fill compartment. See REFILL CAPACITIES. Start engine and check oil level. Oil should be up to FULL mark on dipstick.7. Install fill cap.(22)Final Drives
1. Remove fill and drain plugs (one each side) and allow oil to drain. 2. Remove covers and filter elements. 3. Remove old elements from covers and install new elements on covers.4. Check seal. Use new one if necessary.5. Install new filter elements and covers. 6. Install drain plugs and fill compartment. See REFILL CAPACITIES. Install fill plugs. 7. Remove and discard breather. Install new breather.(23)Winch Oil Sump
1. Remove fill and drain plugs. Allow oil to drain. Do Items (19) and (20).2. Clean and install drain plug.3. Fill compartment until oil is visible in the sight gauge. See REFILL CAPACITIES. Clean and install fill plug. 4. Check oil level with engine running at low idle. Oil level must be visible in sight gauge.(24)Winch Breather
Remove and discard breather. Install a new breather.(25)Universal Joint
Remove floor plate and lubricate 2 fittings.
Slowly lubricate with a lever-type hand gun. Use of pressure type lubricating equipment will cause the seals to be damaged.