ADAPTER-PIPE 2609249 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     4C-8982 (1)     Installer     1    
438-9547 (2) Installer     1    
7F-8022 Bolt     1    
( 1 ) Use to install 9Y-9895 seal
( 2 ) Use to install 362-8853 seal
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00488110
Note: Once the seal and the wear sleeve are separated, these components cannot be used again. Refer to Special Instruction, SMHS8508 before the seal is serviced.Note: Do not use any type of lubricant during the installation of the crankshaft seal and wear sleeve.Note: Before installing the wear sleeve, inspect the crankshaft for scratches or any distortion on the surface of the crankshaft that may lead to an out of round condition. Use a polishing cloth to clean the imperfections on the crankshaft.
Install crankshaft front seal (1) and wear sleeve (2) with Tool (A) , as follows:
Use 4C-9500 Quick Cure Primer to clean the outside diameter of crankshaft (3) and the inside diameter of wear sleeve (2) .
Apply 4C-9507 Compound to the outside diameter of crankshaft (3) and the inside diameter of wear sleeve (2) .
Place crankshaft front seal (1) and wear sleeve (2) on the front of crankshaft (3) . Install Tool (A) and tighten until the inside surface of the Installer comes in contact with the end of the crankshaft.End By: Install the vibration damper and the pulley. Refer to Disassembly and Assembly, "Vibration Damper and Pulley - Remove and Install".