ADAPTER-CPRSN 2681971 - Caterpillar

Illustration 7 g01785494
Left front fender (inside)
Illustration 8 g01785353
Illustration 9 g01705895
Typical machineMake sure that all of the messages are legible. Clean the messages or replace the messages if you cannot read the words. When you clean the messages, use a cloth, water and soap. Do not use solvent, gasoline, or other harsh chemicals to clean the messages. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the messages. Loose adhesive will allow the messages to fall. Replace the illustrations if the illustrations are not legible. Replace any message that is damaged, or missing. If a message is attached to a part that is replaced, install a message on the replacement part.Your Caterpillar dealer has the trained personnel and the correct tools for this procedure.Hydraulic Implements (1)
This message is located inside the left front fender below the left cab door.
Illustration 10 g01130108
Fuel Tank Drain (2)
This message is located inside the left front fender below the left cab door. The message is near to the plunger.ReferenceRefer to Illustration 7.
Illustration 11 g01131127
Open the drain valve. Place hose in a container. Unlock the plunger. Pump the plunger until all the water is removed. Close the drain valve. Lock the plunger.Air Conditioner (3)
This message is located in the cab below the dash (if equipped).
Illustration 12 g00983944
ReferenceFor information on the cooling system, refer to Special Publication, SEBU6250, "Caterpillar Machine Lubricant Recommendations".Unlock (Cab Door) (4)
This message is located on the inside door post.
Illustration 13 g01130067
Depress the button in order to unlock the door. Depress the button in order to release the door from the locked, open position.Implement Control (5)
This message is located in the cab on the lower right hand side of dash.
Illustration 14 g01782294
Electrical Disconnect (6)
This message is located on the right side of the machine inside the enclosure in front of the battery compartment.
Illustration 15 g01130075
Consult your Caterpillar dealer for replacement of messages.Data Privacy (7)
This message is located on the window inside the cab (if equipped).
Illustration 16 g01418953
The Product Link System is a satellite communication device that transmits information regarding the machine back to Caterpillar and Caterpillar dealers and customers. All logged events and diagnostic codes that are available to the Caterpillar Electronic Technician (ET) on the CAT data link can be sent to the satellite. Information can also be sent to the Product Link System. The information is used to improve Caterpillar products and Caterpillar services.Refer to Operation and Maintenance Manual, "Product Link" for more information.General Purpose Bucket (8)
Corner Guard System (If Equipped)This message is located on the back of the bucket.
Illustration 17 g01130760
Bucket designed to accept corner guard system. For maximum life, do not operate bucket without proper corner guard system components. See your Dealer for adaptability of teeth or bolt on edges.