ADAPTER 2752759 - Caterpillar

Specifications
Illustration 1 g01861335
Typical example
Table 1
Specifications for 345-6927 Glow Plug Gp    
Callout     Part Number     Part Name     Specification Description    
1     -     Nut     Torque to...................
2 N m (18 lb in)    
2     361-9875     Glow Plug     Torque to...................
15 N m (11 lb ft)
Voltage........................12V or 24V    
4     133-5512     Nut     Torque to...................
6 N m (53 lb in)    Removal Procedure
Start By:
Remove the inlet elbow and inlet air control (NRS Induction Mixer). Refer to Disassembly and Assembly, "Inlet Air Control (NRS Induction Mixer)" for the correct procedure.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Turn the battery disconnect switch to the OFF position.
Illustration 2 g02025312
Illustration 3 g02025313
Remove nut (3) from the terminal insulator.
Disconnect wire (4) from the terminal insulator.
Remove nuts (1) that secure busbar (2) to the glow plugs (5) .
Remove the busbar from the glow plugs.
Clean the area around the glow plugs. Ensure that the area is free from contamination before removal of the glow plugs.
Remove glow plugs (5) from cylinder head (6) .Installation Procedure
Table 2
Required Tools    
Tool     Part Number     Part Description     Qty    
A     247-5377     Torque Wrench     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 4 g02025313
Before installing glow plugs (5), ensure that the glow plugs are operating correctly. Refer to Troubleshooting, "Glow Plug Starting Aid - Test" "Check the Operation of the Glow Plugs" for the correct procedure.
Ensure that the threads of the glow plugs are clean and free from damage. Replace any damaged glow plugs.
Install glow plugs (5) into cylinder head (6). Tighten the glow plugs to a torque of 15 N m (132 lb in).
Illustration 5 g02025312
Position busbar (2) onto the glow plugs. Install nuts (1) onto the glow plugs.
Use Tooling (A) to tighten nuts (1) to a torque of 2 N m (17 lb in).
Connect wire (4) to the stud on the terminal insulator.
Install nut (3) to the stud on the terminal insulator. Tighten the nut to a torque of 6 N m (53 lb in).
Turn the battery disconnect switch to the ON position.End By: Install the inlet elbow and inlet air control (NRS Induction Mixer). Refer to Disassembly and Assembly, "Inlet Air Control (NRS Induction Mixer)" for the correct procedure.