ADAPTER 2830640 - Caterpillar

Bulldozer Blade Tilt
1. To lower the left side of the blade, pull the tilt lever toward you.2. To lower the right side of the blade, push the tilt lever away from you.3. If additional tilt is required, the left brace may be adjusted. Shorten the brace to make left side of blade lower. Lengthen the brace to make the left side of blade higher.If the tilt brace length needs alteration, turn the handle to the left (counterclockwise), to lengthen it. Turn the handle to the right (clockwise) to shorten the brace.Bulldozer Blade Tip
To tip the blade forward, lengthen the left brace and right cylinder.To tip the blade back, shorten the left brace and right cylinder.Track
If tracks are too tight or loose, wear of components is accelerated. If they appear too tight or too loose, have the track adjusted. Follow the procedures in the "Maintenance Guide" for adjustment.
Ripper Tips and Shank Protector
Replace ripper tips or shank protectors, before wear occurs on the shank. Follow the procedures in the "Maintenance Guide" for replacement.Cutting Edges and End Bits
Replace or reverse the cutting edges or end bits, before wear occurs on the blade base.Winching
The winch has an adjustable sequence valve, which permits the selection of either "inching" or "no inch" characteristics during reel in and reel out operations.Inching is the controlled movement of the cable during a reel in or reel out operation. The INCH setting is generally used when the tractor and winch are used for construction and pipeline work. This setting gives the operator the control necessary to put an object in an exact position.Where precision control is not necessary, like when logs are moved, the NO INCH setting is best to use.When using the inching setting, move the winch control lever to either the reel in or reel out channel. Move the lever into the channel to start drum rotation. Use the engine speed to control the inching rate. Always use a slower engine speed for better control when inching.The adjustable sequence valve, is set on the INCH setting at the factory.To Adjust:
1. Remove the cover. 2. Remove the plug from the end of the valve (1). Use a screwdriver and turn the stop assembly (2). The slot in the stop assembly must be aligned with either the "inch" or "no inch" mark. Install the plug and cover.