ADAPTER AS-DRAIN 2904523 - Caterpillar

Introduction
The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.Problem
Illustration 1 g01364716
(1) Tilted top of the transformerThe transformers are being deformed due to high pressure in the spark plug well. An indication of high pressure is a popping sound when the transformer is removed.The above condition can cause an internal tear in the potting material of the transformer. Many of the transformers continue to be operational. However, some transformers have failed. This problem can be identified by a tilted appearance of the top of the transformer. This tilt is a result of the internal tear. Refer to Illustration 1.Improper maintenance is a root cause for the high-pressure buildup in the spark plug well. A leak path is created when the sealing surface is not properly cleaned. A leak path is created when a new seal is not installed with a spark plug. This leak path allows a pressure buildup of combustion gases in the spark plug well.Poor maintenance of the spark plugs is a major contributor to damaged transformers. Damage due to poor maintenance is not warrantable.Solution
Removing the Spark Plug
Ignition systems can cause electrical shocks. Avoid contacting the ignition system components and wiring.Do not attempt to remove the valve covers when the engine is operating. The transformers are grounded to the valve covers. Personal injury or death may result and the ignition system will be damaged if the valve covers are removed during engine operation. The engine will not operate without the valve covers.
Pressurized air can cause personal injury. When pressurized air is used for cleaning, wear a protective face shield, protective clothing, and protective shoes.
Follow this procedure when a spark plug is removed. Perform this procedure if a transformer with a tilted top is noticed.Debris may have collected in the spark plug well. Thoroughly remove any debris. Use compressed air. The maximum air pressure for cleaning purposes must be below 207 kPa (30 psi). Ensure that the area around the spark plug is clean and free of dirt and debris.Use a 216-1685 deep well socket, an extension, and a breaker bar to loosen the spark plug. After the spark plug has been loosened, use the socket and extension to remove the spark plug by hand in order to detect problems with the threads. After the spark plug has been removed, discard the used spark plug gasket.If the spark plug resists removal by hand, apply penetrating oil to the threads. To help the oil penetrate the threads, turn the spark plug back and forth until the spark plug is loose.If the spark plug could not be removed by hand, clean the threads with a 9U-7511 Spark Plug Seat Cleaner . This tool scrapes debris from the seat and from the threads in the cylinder head. Be sure to clean any debris from the cylinder.
Do not use a thread tap. A thread tap will remove metal unnecessarily. The threads could be stripped and the