ADAPTER-SENSOR 2975393 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 138-7575 Link Bracket 1
ZZ 6V-9511 Face Seal Plug 4
6V-9509 Face Seal Plug 2
6V-9512 Face Seal Plug 2
6V-9832 Cap Assembly 4
6V-9830 Cap Assembly 2
6V-9833 Cap Assembly 2 Note: SERVICE DATA: TOOLING (ZZ) WILL NOT BE IDENTIFIED IN PHOTOGRAPHS IN THE REMOVAL OR THE INSTALLATION. THIS TOOLING IS SHOWN IN ORDER TO ASSIST THE EXPERIENCED SERVICEMAN.Note: Put identification marks on all hoses, on all hose assemblies, on all wires, and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Drain the hydraulic system oil into a suitable container for storage or for disposal. The capacity of the hydraulic system is approximately 300 L (79 US gal). Refer to Operation and Maintenance Manual, "Capacities (Refill)". Refer to Operation and Maintenance Manual, "Hydraulic System Oil - Change" for the correct procedure.
Illustration 1 g00979701
Open grill assembly (1).
Illustration 2 g00979702
Install Tooling (A) on cover (2). Use a suitable lifting device to remove cover (2).
Illustration 3 g00979703
Disconnect hose assemblies (3), (4), (5), and (6).
Disconnect hose assemblies (7), (8), (9), and (10).
Illustration 4 g00979704
Support piston pump (11) with a suitable lifting device. The weight of piston pump (11) is approximately 80 kg (175 lb). Remove bolts (12) and remove the piston pump.