ADAPTER AS 3196208 - Caterpillar

Hydraulic System
Always lower all equipment before servicing hydraulic system. Stop engine and wait at least 5 minutes before servicing filter elements.Cooling System
Use clean water that is low in scale forming minerals - not softened water.Never add coolant to an overheated engine. Allow engine to cool first. Add Caterpillar Rust Inhibitor to coolant except when using permanent-type anti-freeze containing rust inhibitors. Check specific gravity of anti-freeze solution frequently in cold weather to assure adequate protection. When draining cooling system, coolant should be warm and loader lever.Cleaning Cooling System
1. Run engine 5 minutes. Stop engine and loosen filler cap to relieve pressure. 2. Remove filler cap. 3. Open drain valve and drain coolant. 4. Close drain valve and fill system with cleaning solution. * 5. Start and run engine 1/2hour. Stop engine and open drain valve. 6. Flush system with clean water until draining water is clear. 7. Close drain valve and fill system with neutralizing solution. ** 8. Start and run engine 10 minutes. Stop engine and open drain valve. 9. Flush system with clear water. 10. Close drain valve and add coolant to proper level.*1 lb. (0,45 kg) Sodium Bisulphate (NaHSO4) per 5 gal. (19 ltr.) water.**1/2 lb. (0,23 kg) Sodium Carbonate Crystals (Na2CO3, 10H2O) per 10 gal. (37,9 ltr.) water. Most commercial cooling system cleaners may be used.Wiring Diagram
Refill Capacities
Serial Number Locations
ENGINE
FRAME