ADAPTER AS 3436391 - Caterpillar

Removal Procedure
Start By:
Remove the hood. Refer to Disassembly and Assembly, "Hood - Remove and Install" in this module.
Illustration 1 g00694012
Note: The air cleaner weighs 34 kg (75 lb).
Fasten a hoist and a nylon lifting strap to air cleaner (3) .
Remove two bolts and washers (1). Remove four bolts and washers (2) .
Illustration 2 g00694031
Disconnect electrical connector (4) for the turbocharger inlet pressure sensor.
Illustration 3 g00694038
Separate the air duct at the joint in Illustration 3. Remove the two O-ring seals.
Remove air cleaner (3) from the machine.
Cover the opening to the turbocharger.Installation Procedure
Note: O-ring seals, gaskets, and seals should always be replaced. A used O-ring may not have the same sealing properties as a new O-ring seal. A reconditioning procedure should not be degraded because of a low cost component such as an O-ring seal or a gasket. Use 1U-6396 O-Ring Assembly Compound during the assembly procedure.
Uncover the opening to the turbocharger.
Install the two O-ring seals.
Illustration 4 g00694012
Note: The air cleaner weighs 34 kg (75 lb).
Fasten a hoist and a nylon lifting strap to air cleaner (3). Position air cleaner (3) on the machine.
Illustration 5 g00694038
Connect the air duct at the joint in Illustration 5.
Illustration 6 g00694031
Connect electrical connector (4) for the turbocharger inlet pressure sensor.
Install four bolts and washers (2) .
Install two bolts and washers (1) .Reference: Refer to Operation and Maintenance Manual, SEBU7247, "Engine Air Filter Primary Element - Clean/Replace" for the correct procedures for service of the air cleaner.End By: Install the hood. Refer to Disassembly and Assembly, "Hood - Remove and Install" in this module.