ADAPTER GP-FAST FILL FUEL 3729056 - Caterpillar

Removal Procedure
Table 1
Tools Needed     A     B    
8S-9906 Ratchet Puller     1     2    
6V-2156 Link Bracket         2    Start By:
Remove the bulldozer blade (angle bulldozer).
Remove the angle cylinders (angle bulldozer).
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide", for tools and supplies suitable to collect and contain fluids in Caterpillar machines.Dispose of all fluids according to local regulations and mandates.
At operating temperature, the hydraulic tank is hot and under pressure.Hot oil can cause burns.Remove the fill cap only when the engine is stopped and the cap is cool enough to touch with your bare hand. Remove the fill cap slowly to relieve pressure.
Note: Put identification on all lines, hoses, wires and tubes for installation purposes. Cap and plug all lines, hoses and tubes to prevent foreign material from entering the system.Note: Drain all fluids in a suitable container for storage or disposal.
Illustration 1 g00673006
Put the fork of a lift in position under C-frame (1), as shown. Use Tool (A), and fasten the C-frame to the lift truck.
Illustration 2 g00673001
Fasten Tooling (B) to the lift cylinders, as shown.
Remove the bolts, retainers and pins (2) that hold the lift cylinders to the C-frame.
Use Tooling (B), and move the lift cylinders away from the C-frame.
Illustration 3 g00672994
Disconnect hose assembly (3) on each side of the C-frame.
Illustration 4 g00672989
Illustration 5 g00672986
Remove the bolts that hold three clips (5) in position. Move the clips and hoses away from the C-frame.
Remove the bolts, retainers and pins (4), and remove C-frame (1) with the lift truck. The weight of the C-frame is 434 kg (957.0 lb).
If necessary, remove the bearings from the tractor main frame.