ADAPTER 3G0169 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     5P-3931     Anti-Seize Compound     -    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
The alignment of the bellows is important. Improper alignment may lead to premature failure of the bellows. Misalignment can be identified by visually inspecting the convolutions for uniformity of compression.Inspect the bellows for damage prior to installation. If there is any damage to the convolutions, discard the bellows. Minor damage to the ends of the bellows may be repaired. However, if there is any difficulty in installation after the repair, discard the bellows.
Illustration 1 g01288409
Install actuator (16) onto clean gas induction valve (14). Install bolts (15) .
Illustration 2 g01288402
Install clean gas induction valve (14) .
Install bolts (13) and the spacers. Tighten clamp (12) to a torque of 11 1 N m (97 9 lb in). Tighten clamp (11) to a torque of 11 1 N m (97 9 lb in).
Illustration 3 g01288392
Connect hose assemblies (10). Connect harness assembly (9) .
Illustration 4 g01288383
The ends of the bellows are very sharp. Injury could occur if the bellows are not handled properly. Handle the bellows by the convolutions.
Note: Refer to Special Instruction, REHS1728, "Application Guideline for the Bellows" for additional information on handling the bellows.
Install duct (4) and bellows (8) .
Apply Tooling (A) onto the threads of clamp (5). Connect clamp (5) and tighten clamp (5) to a torque of 12 2 N m (106 18 lb in). Apply Tooling (A) onto the threads of clamp (2). Connect clamp (2) and tighten clamp (2) to a torque of 12 2 N m (106 18 lb in). Position tube assembly (6) and harness assembly (7). Connect harness assembly (7). Connect tube assembly (6). Position tube assembly (1). Position the clips and install nut (3). Connect tube assembly (1) .