ADAPTER-STRAP 4T7554 - Caterpillar

4T7554 ADAPTER-STRAP Caterpillar parts 973, 988F, 988F II

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA4T7554
4T-7554
4T7554

Weight: 56 pounds 25 kg.

Information:

BEVEL ANGLE 22.5

BLUNT HEIGHT MAX 15 mm

EDGE LOCATION CENTER

EDGE THICKNESS 54 mm

GAGE SIZE J550

NOSE ANGLE O/T

Buy ADAPTER-STRAP 4T7554 Caterpillar genuine, new aftermarket tractor parts with delivery
TRACK LOADER, WHEEL LOADER,

Compatible equipment models: 4T7554:

TRACK LOADER 973

WHEEL LOADER 988F 988F II Caterpillar

Number on catalog scheme: 10

Caterpillar 4T7554 Parts scheme ADAPTER-STRAP

For full view, you need register

Information:

Procedure to Flash Program the ECM
Connect the data link cable between the communication adapter and the electronic technician.
Connect the data link cable between the communication adapter and the diagnostic connector of the machine.
Turn the disconnect switch and the key start switch to the ON position.
Set the implement lockout to the LOCKED position.
Make sure that the transmission direction switch is in the neutral position.
Verify that the engine is not running.
Use WinFlash to load the software.Perform the Following Procedure Only if the Normal Flashing Process Fails.
Key OFF the machine.
Open the battery disconnect switch for a minimum of one minute.
Illustration 1 g03327419
(1) "OK" button (2) "Back" button (3) "Operator Select" button (4) "Information" button
Depress and hold the top four buttons on the display ("OK", "Back", "Operator Select" , and "Information") while turning the key switch ON.Note: To perform Step 4, a second person is required.
While continuing to hold the four buttons in the depressed position, and with the key switch ON, close the battery disconnect switch.
The display will come up in boot loader mode.
Use Cat ET WinFlash to flash the appropriate application software for the display.