ADAPTER 5042756 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Krytox GPL 205 -
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Verify that the air lock lever is in the closed position.
Illustration 1 g03863735
Loosen hose clamps (1) and clamp assemblies (2) enough to allow the compressor covers to rotate. Note: Excessive loosening of the housing will cause contact, and possible damage to the wheel may occur.
Illustration 2 g03863779
Remove bolts (3) and bracket (7). There are four bolts in total.
Disconnect left-hand compressor cover (5) from air lines group (4). Rotate right-hand compressor cover (6) and air lines group (4) clockwise until air lines group (8) can be disconnected from the right-hand compressor cover (6) and removed. Note: Use caution not to damage seals (4) when removing air lines group (8).Installation Procedure
Illustration 3 g03863779
Lightly lubricate the bore of compressor cover (5) and compressor cover (6).
Apply Tooling (A) to seals (4).
Install the air lines group (8) to the right-hand compressor housing (6). Rotate left-hand compressor housing (5) and the air lines group (8) towards each other and insert the integral seal into the left-hand compressor housing.
Install bolts (3) and bracket (7). There are four bolts in total.
Illustration 4 g03863735
Position clamp assemblies (2) on the top side of the turbocharger, pointing outward.
Tighten clamp assemblies (2) to a torque of 14 1 N m (124 9 lb in). Tap the clamp lightly all around. Tighten to 14 1 N m (124 9 lb in).
Tighten hose clamps (1).