ADAPTER GP-TIP 5395795 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     138-7575     Link Bracket     1    
B     1U-9200     Lever Puller Hoist     1    
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Release the hydraulic system pressure. Refer to Disassembly and Assembly, "Hydraulic System Pressure - Release".
Illustration 1 g00607129
Remove bolts (3), retainer (2), and pin (1) from each side.
Illustration 2 g03512476
Start the engine and retract the lift cylinder rods. Use a nylon rope or use wire in order to secure the lift cylinder rods.
Release the hydraulic system pressure. Refer to Disassembly and Assembly, "Hydraulic System Pressure - Release".
Fasten shipping brackets (4) on the lift cylinder to the radiator guard.
Illustration 3 g03512483
Disconnect tilt cylinder hose assemblies (5). Place protective covers over the openings. Fasten the left lift cylinder shipping bracket to the radiator guard.
Illustration 4 g00607153
Attach Tooling (A) to link assembly (7) .
Attach Tooling (B), as shown. Attach the top end of Tooling (B) to the lift cylinder yoke.
Remove cap (6) and remove the shims .Note: Do not remove the suitable lifting device from link assembly (7) .
Illustration 5 g00607161
Position suitable cribbing beneath the push arms. Remove caps (8) and the shims from the push arms.
Illustration 6 g00607210
Illustration 7 g00607214
Start the engine. Move the machine in a rearward direction 150 mm (6.00 inch) to Dimension (X). Carefully move the front of the machine to the left. Move enough that the link assembly may be lowered to the ground.
Remove Tooling (B). Carefully move the machine away from the bulldozer.Installation Procedure
Install the bulldozer in the reverse order of removal.
Check the hydraulic oil level. Refer to Operation and Maintenance Manual, "Hydraulic System Oil Level - Check".