ADAPTER AS 5564734 - Caterpillar

Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin.At operating temperature, the engine coolant is hot and under pressure.Steam can cause personal injury.Check the coolant level only after the engine has been stopped and the fill cap is cool enough to touch with your bare hand.Remove the fill cap slowly to relieve pressure.Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury.Pressure air can cause personal injury.When using pressure air for cleaning, wear a protective face shield, protective clothing and protective shoes.The maximum air pressure must be below 205 kPa (30 psi) for cleaning purposes.
Walk-Around Inspection
For maximum service life of the machine, make a thorough walk-around inspection before mounting the machine to start the engine.Look around and under the machine for such items as loose bolts, trash build-up, oil or coolant leaks, broken or worn parts. Inspect the condition of the implements and the hydraulic components. 1. Inspect the implements for damage or excessive wear. Repair if damaged.2. Inspect implement cylinders and linkage for damage or excessive wear. Repair if damaged. 3. Inspect and replace lights, broken bulbs and lenses. 4. Use commercially available window cleaning solutions to clean the windows. 5. Inspect and remove any trash build-up in and around the engine.6. Inspect and repair any cooling system or engine component leaks. 7. Check the air filter for restriction. If the air filter light on the instrument panel comes ON, service the engine air filter. 8. Inspect steps and handholds for condition and cleanliness. Repair or clean if necessary. Inspect the Falling Object Protective Structure (FOPS) (if equipped) for damage. Tighten any loose bolts. Repair if necessary. 9. Inspect the hydraulic system for leaks. Inspect the tank, hoses, tubes, plugs, joints and fittings. Correct any leaks.10. Inspect and repair any final drive leaks. Check the oil level if leakage is noticed.11. Be sure covers and guards are firmly in place. Inspect for damage.12. Inspect and repair any swing drive leaks.13. Inspect and replace damaged and worn track. See your Caterpillar dealer for service if needed. 14. Inspect operator's compartment for cleanliness and remove all trash.15. Inspect and repair the instrument panel when broken gauges and lights are found. 16. Inspect seat belt mounting hardware for excessive wear and damage. Replace if damaged.Pre-Start Check
1. Open the engine access covers to gain access to the engine compartment and the coolant reservoir. 2. Check to be sure that the oil level is between the marks on the dipstick. 3. Observe the coolant level in the reservoir. Maintain the coolant level between the LOW and FULL marks on the reservoir. 4. Machine must be on level ground with bucket cylinders extended and the bucket on the ground to measure the hydraulic oil.Clamshell bucket should be opened and on the ground. 5. Observe the hydraulic oil level. Maintain the oil level between the marks in the appropriate temperature range. 6. The fuel tank drain valve is located