ADAPTER AS- 5660069 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     5P-6215     Jack Stand     2    Start By:
Remove the track. Refer to Disassembly and Assembly, "Track - Remove and Install".
At operating temperature, the hydraulic oil is hot and under pressure. Hot oils can cause burns.To prevent possible personal injury, release the pressure in the work tool hydraulic circuit (boom, stick, bucket, and swing), travel circuits, and the hydraulic oil tank at the filler cap before any hydraulic lines or components are disconnected or removed.Remove the filler cap only when the engine is stopped and the filler cap is cool enough to touch.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g00538695
Note: Adjust the height of Tooling (A) so that there is enough clearance between the sprocket and track links for removal of the final drive and motor.
Raise the side of the machine and install Tooling (A) under the frame, as shown.
Illustration 2 g00538723
Rotate the final drive until drain plug (1) is at the bottom. Drain the oil into a suitable container for storage or disposal.
Release the hydraulic system pressure. Refer to Disassembly and Assembly, "System Pressure - Release".
Illustration 3 g00538793
Remove bolts (2) and cover (3) from the rear of the undercarriage frame.
Illustration 4 g00597225
Disconnect hose assemblies (4) .
Illustration 5 g00597227
Attach a suitable lifting device to final drive and travel motor (6). Remove bolts (5). Remove final drive and travel motor (6). The combined weight of final drive and the travel motor (6) is approximately 118 kg (260 lb).