ADAPTER 5N2611 - Caterpillar

Assembly Procedure
Note: Cleanliness is an important factor. Before you begin the assembly procedure, the exterior of the components should be thoroughly cleaned. Dirt will be prevented from entering the internal mechanism. Precision components can be damaged by contaminants or by dirt. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g03710336
Install bearings (15) into body (1) .
Illustration 2 g00905027
Install shaft (12), shaft (13), and shaft (14) into body (1) .
Illustration 3 g00905024
Install bearings (11) into cover (10) .
Illustration 4 g00905023
Illustration 5 g00905020
Install cover (10) onto body (1) .
Install bolts (9) into cover (10) .
Illustration 6 g00905016
Install gasket (8) into cover (7) .
Illustration 7 g00905012
Illustration 8 g00905011
Install cover (7) onto body (1) .
Install bolts (6) into cover (7) .
Illustration 9 g00905008
Illustration 10 g00905007
Illustration 11 g00905006
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install spool (5) and spring (4) into body (1) .
Install cover (3) and bolts (2) into body (1) .End By: Install the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Install".