ADAPTER 6E1926 - Caterpillar

Illustration 2 g03892282
Section D-D
Table 2
Item Qty Part Specification Description
8 2 3E-8010 Bolt Before assembly, outer diameter, inner diameter, and mating surfaces to be clean:
1. Apply Loctite C5A copper anti seize to the threads of the bolt.
2. Tighten bolt to 1800 200 N m (1328 148 lb ft).
3. Tap the joint until the torque drops lower than 950 N m (701 lb ft).
4. Tighten bolt to 1800 200 N m (1328 148 lb ft).
5. Apply a second impact until the torque drops to less than 1600 N m (1180 lb ft).
6. Tighten bolt to 1800 200 N m (1328 148 lb ft).
7. Torque bolt to 1800 200 N m (1328 148 lb ft) after 50 hours of vehicle operation.
9 2 389-4917 Collet Before assembly, outer diameter, inner diameter, and mating surfaces to be clean. Apply Loctite C5A copper anti seize to the outer diameter and inner diameter of the collet.
10 4 420-1507 Pin Seal Before assembly, apply red Loctite 263 to the bore.
11 2 389-4937 Collet Before assembly, outer diameter, inner diameter, and mating surfaces to be clean. Apply Loctite C5A copper anti seize to the outer diameter and inner diameter of the collet.
Illustration 3 g03892283
Section E-E
Table 3
Item Qty Part Specification Description
12 8 154-7204 Collet Before assembly, outer diameter, inner diameter, and mating surfaces to be clean. Apply Loctite C5A copper anti seize to the outer diameter and inner diameter of the collet.
13 2 3E-8012 Bolt Before assembly, outer diameter, inner diameter, and mating surfaces to be clean:
1. Apply Loctite C5A copper anti seize to the threads of the bolt.
2. Tighten bolt to 1800 200 N m (1328 148 lb ft).
3. Tap the joint until the torque drops lower than 950 N m (701 lb ft).
4. Tighten bolt to 1800 200 N m (1328 148 lb ft).
5. Apply a second impact until the torque drops to less than 1600 N m (1180 lb ft).
6. Tighten bolt to 1800 200 N m (1328 148 lb ft).
7. Torque to 1800 200 N m (1328 148 lb ft) after 50 hours of vehicle operation.
Illustration 4 g03892284
Section F-F
Illustration 5 g03892375
Section G-G
Table 4
Item Qty Part Specification Description
14 Use shims as required to eliminate gaps between lift arm and bucket:
12 103-1814 Shim Thickness is 3.0 mm (0.12 inch).
6 103-1815 Shim Thickness is 5.0 mm (0.20 inch).