ADAPTER ASSEM. 6N5898 - Caterpillar

Illustration 57 g01328666
Remove thrust discs (106), bearings (108), and planetary gears (107) from the carrier assembly.
Remove spring pins (109) from planetary shafts (105).
Illustration 58 g01328671
Remove bearing (110) from sun gear (102).
Illustration 59 g01328676
Remove O-ring seal (111) from sun gear (102).
Illustration 60 g01328683
Remove plate (112).
Illustration 61 g01328691
Remove friction discs (113) and clutch plates (116). Remove O-ring seals (114) and (115).
Illustration 62 g01328718
Use several small steel rods (117) ( 2.36 mm (0.0930 inch) diameter and one pointed tip) to compress the retaining ring that holds coupling (119) to carrier assembly (118). Remove coupling (119) from carrier assembly (118).Note: Coupling (119) and carrier assembly (118) may be removed together at this time. Use small steel rods (117) to separate coupling (119) and carrier assembly (118). See Step 46 for similar actions.
Illustration 63 g01328725
Remove clutch piston (120) from the clutch housing. Remove carrier assembly (118).
Illustration 64 g01328730
Remove seal rings (121) and (122) from clutch piston (120).
Illustration 65 g01328733
Use Tooling (E) to remove retaining ring (123). Use Tooling (B) to remove bearing (124).
Remove seal ring (125) from carrier assembly (118).
Illustration 66 g01328737
Use a hammer and a suitable punch to push the spring pins through carrier assembly (118) and into planetary shafts (126).
Use a hammer and a suitable punch to remove planetary shafts (126) from carrier assembly (118).
Illustration 67 g01328740
Remove thrust discs (127), planetary gears (128), and bearings (129) from the carrier assembly. Remove spring pins (130) from planetary shafts (126).
Illustration 68 g01328743
Use Tooling (E) to remove retaining ring (131) from housing (132).
Use a suitable soft hammer to remove input shaft (133) from housing (132).
Illustration 69 g01328750
Remove ring seals (135) and O-ring seal (136) from input shaft (133). Remove bearing (134).
Illustration 70 g01328760
Use Tooling (C) and a suitable press to remove race (137) from input shaft (133).