ADAPTER 6V3094 - Caterpillar

Assembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A Tube with an inside diameter of 31 mm (1.22 inch) 1 Note: Check all of the O-ring seals and the components for wear or for damage. Replace the components, if necessary. Lubricate all of the O-ring seals lightly with the lubricant that is being sealed. Clean all of the components with a cloth that is free of loose material (lint).
Illustration 1 g00644997
Position retainer (1) on sensor rotor (3), as shown.
Position ball bearing (2) on sensor rotor (3). Use Tool (A) and a suitable press in order to install ball bearing (2) in sensor rotor (3).
Illustration 2 g00645001
Install retaining ring (4) in groove (X) on the sensor rotor.
Illustration 3 g00645007
Position sensor housing (5), as shown. Rotate the retainer so that the flat edge (Z) is positioned directly over opening (Y) in the sensor housing.
Illustration 4 g00645009
Install O-ring seal (6) on speed sensor (7). Make sure that the adjustable cap on speed sensor (7) is fully extended.
Install speed sensor (7) in sensor housing (5). Tighten speed sensor (7) to a torque of 25 5 N m (18 4 lb ft). End By:
Install the transmission speed sensor. Refer to Disassembly and Assembly, "Speed Sensor (Transmission) - Install".