ADAPTER-SOCKET 6V3123 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 6V-3145 Load Leveler 1
B 0S-1626 Bolt 3
B 5P-8248 Washer 6
C 6V-0006 Pliers 1 Note: Check all of the components for wear or for damage. Replace the components, if necessary. Clean all of the components with a cloth that is free of loose material (lint).
Illustration 1 g00647522
Attach Tool (A) to the transmission. Secure Tool (A) to the hoist. Position the transmission, transfer gears and differential onto the axle housing assembly, as shown. The weight of the transmission, transfer gears and differential is 2223 kg (4900 lb).
Illustration 2 g00647527
Install two full nuts (15) and the washers that hold the differential and bevel gear to the rear axle housing. Tighten full nuts (15) to a torque of 430 60 N m (317 44 lb ft).
Install 26 full nuts (14) and the washers that hold the transmission in position. Tighten full nuts (14) to a torque of 430 60 N m (317 44 lb ft).
Remove Tooling (B) from location (X). Location (X) occurs three times around the circumference of the transmission.
Illustration 3 g00645665
Connect hose assembly (13) to the bottom of the transmission.
Illustration 4 g00645662
Connect hose assembly (12) to the transmission.
Illustration 5 g00645660
Connect hose assembly (10). Connect wire harness (9) at the electrical connection. Install two clips (11).
Illustration 6 g00645656
Connect two wire harnesses (7) at the electrical connections. Install bolt (8) and the hard washer.
Illustration 7 g00644984
Connect wire harness (4) to speed sensor (6). Tighten the nut clockwise with Tool (C) (not shown) and insert lockwire (5) to the next hole in the clockwise direction.
Illustration 8 g00644981
Install the clip (not shown) that is under the guard. Position guard (2) on the speed sensor. Install the spacer, the grommet, the hard washer, and bolt (3). Install bolt (1) and the washer.
Illustration 9 g00647568Note: Refer to Power Train, Testing and Adjusting, "Differential and Bevel Gear - Adjust" for the correct procedure to adjust pin (19).
Install O-ring seal (18) on pin (19). Install pin (19) in the axle housing assembly.
Illustration 10 g00647529
Install the shim pack, cover (17), two bolts (16), and the washers.
Fill the transmission and the transmission tank with oil. The capacity of the transmission tank is 95 L (25 US gal). The capacity of the transmission system is 246 L (65 US gal). Refer to the Operation and Maintenance Manual, "Transmission Tank Oil - Change" for the correct procedure.
Fill the axle housing assembly with oil. The capacity of the axle housing assembly is 222 L (59 US gal). Refer to the Operation and Maintenance Manual, "Differential and Final Drive Oil - Change" for the correct procedure. End By:
Install the axle shafts. Refer to Disassembly and Assembly, "Axle Shaft - Install".
Install the main drive shaft. Refer to Disassembly and Assembly, "Drive Shaft (Main) - Install".