ADAPTER 7C2565 - Caterpillar

Installation Procedure
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g00709982
Note: Use two persons to install the oil cooler.
Carefully install oil cooler (18) . The weight of the oil cooler is 16 kg (35 lb).
Install the washers and four bolts (24) in the oil cooler.
Illustration 2 g00709964
Install the bolt, the washer, and nut (23) in the bottom of the oil cooler.
Illustration 3 g00709797
Place panel (22) in position. Install the washers and five bolts (21) .
Illustration 4 g00709799
Connect tube (19) to oil cooler (18) . Install the washers and four bolts (20) .
Illustration 5 g00709954
Place refrigerant condenser (15) in position. Install the washers and two bolts (16) .Note: Make sure that handle (17) is latched.
Install two bolts (14) , two washers, and two nuts on the mounting bracket.
Illustration 6 g00709996
Place two screens (12) in position. Install three screws (13) .
Illustration 7 g00709802
Place the support and air filter (9) in position on the machine. Install the washers and bolts (11) .
Illustration 8 g00709992
Connect two electrical connectors (10) to air filter (9) .
Illustration 9 g00718065
Connect hose (7) to the air cleaner housing. Tighten hose clamp (8) .
Illustration 10 g01334476
Close side doors (6) .
Illustration 11 g00709977
Place cover (5) in position. Install the washers and four bolts (4) .
Close engine hood (3) .
Place cover (2) in position. Install the washers and four bolts (1) .
Install high efficiency filters in place of the pilot filter, the case drain filter, and the return filter.Note: High efficiency filters should not be run for more than 250 hours before you change back to the standard filters.
Install the drain plug in the hydraulic oil tank. Fill the hydraulic oil tank with oil to the correct level.ReferenceRefer to the Operation and Maintenance Manual for the correct filling procedure and the correct oil level.
Obtain a hydraulic oil sample from the main S O S port.ReferenceRefer to Operation and Maintenance Manual, "Sampling Interval and Location of Sampling Valve" for the correct location.
If the S O S sample exceeds ISO 18/15, flush the hydraulic system.ReferenceRefer to Contamination Control Guidelines, SEBF8436, "Hydraulic System Flushing Procedure for 320C Hydraulic Excavators" for further information.