ADAPTER 7E3393 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     5F-4764     Pry Bar     1    Start By:
Remove the rocker arms and the rocker arm shaft. Refer to Disassembly and Assembly, "Rocker Arm and Shaft - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01150587
Disconnect harness assembly (1) .Note: Note the orientation of the bridge assemblies for installation purposes.
Remove bridge assemblies (3) .
If the injector hold down bolt is loose during the removal procedure, inspect the injector bore for wear and debris. Replace the clamp and spacer.
Remove bolt (4) , spacer (5) , and clamp (6) .
Place an identification mark on electronic unit injectors (2) for installation purposes. Each electronic unit injector (2) must be reinstalled in the original location in the cylinder head.
Illustration 2 g01073439
Use Tooling (A) to pry beneath the base and free electronic unit injector (2) .
Remove electronic unit injector (2) from the cylinder head.