ADAPTER-FAN 7W3464 - Caterpillar

Warning Levels
The ECM will assign one of the three warning levels to an active event code according to the severity of the abnormal system condition. Each warning level requires a specific response from the operator. The warning levels and required operator response are listed below.Warning Level 1
Warning level 1 alerts the operator that a machine system requires attention. The operator should check the involved system. Perform any necessary maintenance to the system at the earliest possible time.Warning Level 2
Warning level 2 requires changing the operation of the machine or performing a maintenance procedure. Failure to correct the address this warning may damage the components involved. The problem that caused the event may require a correction before the machine may resume operation.Warning Level 3
Warning level 3 requires an immediate safe shutdown of the machine to avoid damage to the machine or injury to personnel around the machine. The problem that caused the event must be corrected before machine operation can resume.Indications and System Response
Message
Table 1
OPERATION
Warning Level Warning Indications Action by the operator is required. Possible Result (1)
Warning Indicators for the Subsystem Warning Lamp Sounding of the Action Alarm
1 ON Solid Amber OFF No immediate action is required. The system needs attention soon. No harmful, damaging effects result.
2 ON Flash Red OFF Change machine operation or perform maintenance to the system. The system components are damaged.
3 ON Flash Red Pulse ON and OFF Immediately perform a safe engine shutdown. The operator is injured or the components are damaged.
(1) (if no action is taken by the operator)Machine > Diagnostics > Events and Details
When an abnormal operating condition occurs, the Events and Details screen on the Information Display indicates that there is an active event.
Illustration 1 g06028787
Example of a Diagnostic Event Page.
Cat® Electronic Technician (Cat ET)
When an abnormal operating condition occurs, the status screen on the Cat ET indicates that there is an active event.Event codes are displayed on Cat ET in the following format:EXXXX Description of the codeThe "E" means that the code is an event code. The "XXXX" is a numeric identifier. The numeric identifier is followed by a description of the code.Active event codes are listed in ascending numerical order. The code with the lowest number is listed first. The active event code is removed from the list when the condition is no longer present.Logged Event Codes
Some event codes are logged in the ECM memory. Some event codes are active only. The logged event codes are listed in chronological order. The most recent code is listed first.A logged code is cleared from memory when one of the following conditions occur:
The service technician manually clears the code.
The code does not reoccur for 1000 hours.
A new code is logged and there are already ten logged codes in memory. In this case, the oldest logged code is cleared.Note: Always clear logged event codes after investigating and correcting the problem which generated the code.Troubleshooting
Perform the following steps to troubleshoot an event:
Obtain the following information from the operator:
The event and the time of the event.
Determine the