ADAPTER-FAN 8N7015 - Caterpillar

10. Inspect the final drives for leaks. Check the oil level if leakage is noticed. 11. Be sure the covers and guards are firmly in place. Inspect for damage.12. Inspect the transmission for leaks. Correct any leaks.13. Inspect the tracks for damage, looseness, tighteness and excessive wear. Correct if needed. 14. Inspect the operator's compartment for cleanliness. Keep it clean.15. Inspect the instrument panel for broken gauges. Replace if broken.
Always check the condition of the seat belt and mounting hardware before operating the machine.Replace the seat belt at least once every three years of use, regardless of appearance. A data label, to determine the age of the belt is sewn onto each belt.
16. Inspect seat belt and mounting hardware.Engine Crankcase
Check Oil Level
Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin.
Oil filler cap. Engine stopped: With the oil cold, maintain oil level between the ADD and FULL marks on the dipstick.Cooling System
Check Coolant Level
At operating temperature, the engine coolant is hot and under pressure.Steam can cause personal injury.Check the coolant level only after the engine has been stopped and the fill cap is cool enough to touch with your bare hand.Remove the fill cap slowly to relieve pressure.Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury.
1. Open the coolant filler cap slowly to relieve any pressure.2. Inspect the condition of the cap gasket. Replace the cap gasket if damaged.3. Maintain the coolant above the low level plate.4. Inspect radiator for leaks or trash build-up.Hydraulic System
Check Oil Level
Hot oil can cause burns.At operating temperature, the hydraulic tank is hot and under pressure.Remove the fill cap ONLY when the engine is stopped, and the cap is cool enough to touch with your hand. Remove the fill cap slowly to relieve pressure.
Never remove the cap from the implement hydraulic tank if the oil is hot. Air can enter the system and cause pump damage.
The hydraulic oil tank is located on the right side of the machine.Maintain the oil level between the ADD and FULL marks in the sight gauge.Fuel System
Drain Moisture and Sediment
1. Open the drain valve and allow the moisture and sediment to drain.2. Close the drain valve.Check Fuel Level
Check fuel level daily. The tank should be full at the start of the shift.Indicators and Lights
Check for Proper Function
Start the engine and look for broken gauge lenses or lights, switches, etc.Back-Up Alarm
Check for Correct Operation
1. With the key switch on, apply the service brakes and place the transmission selector lever in REVERSE.2. The alarm should start to sound immediately. It will continue to sound until the transmission selector is moved to NEUTRAL or FORWARD.Air Induction System
Inspect Precleaner
Service air cleaner with engine stopped.
1. Inspect for dirt accumulation. Remove and empty the bowl when the dirt accumulation reaches the FULL line.2. Loosen the wing nut and remove the cover. Empty the dirt from the precleaner cup.3. Replace the precleaner cup and cover and tighten the wingnut finger