ADAPTER 8S6587 - Caterpillar

1. Remove the hood. The weight of the hood is approximately 37 Kg (82 lb.).2. Drain the coolant from the radiator.3. Drain the oil from the hydraulic tank. 4. Loosen the clamps and move hoses (1) and (2) down on the lower tube assemblies. If necessary, loosen clamp (3). 5. Loosen the clamps and move hose (4) on to tube (5). 6. Disconnect wire harness (6). Remove the bolt and disconnect the clip and wire (7) from the frame. 7. Loosen the clamps and move hose (9) on to tube (8). 8. Remove the bolt and disconnect clip (10) that holds the battery cables to the guard. 9. Fasten strap (13) and a hoist to fan assembly (11) and remove bolts (12).
Do not damage the radiator core with the fan assembly when fan is disconnected from the fan drive.
10. Carefully lower fan assembly (11) into the radiator guard. 11. Fasten strap (14) and a hoist to grille (15). Remove the bolts and grille (15) from the guard. The weight of the grille is approximately 23 Kg (50 lb.). 12. Fasten tool (A), straps (16) and a hoist to radiator, oil cooler and guard (17) as shown. 13. Remove six bolts (18) that hold the guard to the frame. Two bolts are behind the rear lights. 14. Remove radiator, oil cooler and guard (17) from the machine. The weight of the guard assembly is approximately 499 Kg (1100 lb.).Install Radiator, Oil Cooler And Guard (Earlier)
1. Fasten tool (A), straps (16) and hoist to radiator, oil cooler and guard (17) and install on the machine as shown. 2. Install six bolts (18) that hold the guard assembly to the machine. 3. Fasten strap (14) and a hoist to grille (15) and install on the guard assembly. 4. Fasten strap (13) and a hoist to fan assembly (11) and put it into position on the fan drive.5. Install bolts (12) that hold fan assembly (11) to the fan drive. 6. Connect clip (10) that holds the battery cables to the guard assembly. 7. Connect wire harness (6) and connect the clip that holds wire (7) to the bottom of the guard assembly. 8. Move hose (4) into position on the elbow and tighten the clamps. 9. Move hoses (1) and (2) on to the lower tube assemblies and tighten the clamps.10. Tighten clamp (3) if it was removed during removal. 11. Move hose (9) into position on to tube (8), and tighten the two clamps.12. Install the hood.13. Fill the radiator with coolant to the correct level. Fill the hydraulic tank with oil to the correct level. See the Maintenance Guide.