ADAPTER 9Y9697 - Caterpillar

Illustration 1 g00387726
Illustration 2 g00448380
The hydraulic tank filler cap is located on the right side of engine compartment on the back side of the machine. Use the prop rod to hold the engine access door open.
Illustration 3 g00402219
Remove the hydraulic tank filler cap.
Illustration 4 g00402220
Illustration 5 g00402218
The hydraulic tank drain valve is located at the bottom of the hydraulic tank. Remove the bottom guard in order to access the drain valve. Open the drain valve and allow the hydraulic oil to drain into a suitable container.
Close the drain valve.
Change the hydraulic system filter and the hydraulic tank breather. Refer to Operation and Maintenance Manual, "Hydraulic System Oil Filter - Change".
Fill the hydraulic system oil tank. Refer to Operation and Maintenance Manual, "Lubricant Viscosities" and Operation and Maintenance Manual, "Refill Capacities".
Inspect the gasket on the hydraulic tank filler cap for damage. Replace the gasket, if necessary.
Install the hydraulic tank filler cap.
Start the engine and run the engine for a few minutes. The brake oil pressure indicator should go out. If the brake oil pressure indicator does not go out, refer to Service Manual, SENR6760-01, "Testing & Adjusting", "Braking System Troubleshooting".
Illustration 6 g00402221
Maintain the hydraulic oil level above the "ADD COLD" mark on the sight gauge. Add oil, if necessary.Note: The oil must be free of bubbles. If bubbles are present in the oil, air is entering the hydraulic system. Inspect the suction hoses and hose clamps.
Stop the engine.
If necessary, tighten any loose clamps and any loose connections. Replace any damaged hoses.
Close the engine access door.