ADJUSTER GP- 1400009 - Caterpillar

(1) Torque for nuts ... 125 11 lb. ft.(170 15 N m) Torque for studs ... 35 10 lb. ft.(100 14 N m)(2) Torque for nuts ... 100 11 lb. ft.(135 15 N m)(3) Torque for bolts ... 100 11 lb. ft.(135 15 N m)(4) Apply 5P960 Multipurpose Type Grease on these surfaces.(5) Adjust shim pack thickness to provide preload of ... .002 to .004 in.(0.06 to 0.10 mm)(6) Install retainer with part number toward sprocket. Bearing Adjustment:Tools Needed: 9S9112 Spanner Wrench The procedure that follows must be used to put the correct amount of preload on the bearings for the final drive: 1. Tighten nut (8) to a torque of 125 lb. ft. (170 N m) with spanner wrench.2. Turn sprocket (7) to put the bearings in their seats.3. Hit the hub of sprocket with a large punch and a hammer.4. Repeat Steps 1, 2 and 3 until nut (8) does not turn when it is tightened.5. Loosen nut (8).6. Tighten nut (8) to a torque of 75 lb. ft. (100 N m).7. If nut (8) is in a locking position, install the axle, retainer (9) and bolts.8. If nut (8) is not in a locking position, tighten the nut to the next nearest locking position. Install the axle, retainer (9) and the bolts.